Home made Goat Miker

So i have spent hours looking and comparing goat milkers all over the internet and i finally found one i liked. The fruit jar milker- So i looked it up and they want $80. to $100. for this little guy! So i decide to make my own! And it works like a charm so i thought i would share! I only spent 25.oo on making this guy! The one i made is only for one teat milker. But you can easily change it up to two.

Fist you will need to buy a food saver -Rechargable Food saver vacume that looks like this.

20160120_004112000_iOS

You can find the vacuum food saver pump on amazon for 19.95. Next you will need a mason jar of your choosing. You will need two “o” rings, 6 foot of small clear hose, A Drill, a small piece of wood and a placstic syringe that will fit your goats teat and silicone. And that is it!

Ok lets get started. Take the top of your canning lid And you want to drill two holes in it so your hose and o rings will fit. It works best with the peace of wood under it.

20160122_195642351_iOS

Next you will want to put your o rings and clear hose threw the holes put a o ring on each side and silicone it so it won’t leak air and will sealed tight.

Next you will take one of the tubes and shove it into the top of the food saver rubber gasket, don’t worry you cant break it, well i am sure you could but it its pretty tough we shoved it through then put silicon on the top and the bottom to make sure it was air tight. Then take the other hose and shove it over the end of the syringe, if its a tight enough seal you wont need to put silicon on it. You can change it so that way you have 3 hoses if you choose to milk two teats at the same time but my one teat milker works just great!

20160122_200530051_iOS

when you get the food saver plug it in leave it plugged in for a full 24 hours then milk your goats run the food saver until it is completely dead, then put it back on the charger. the lid is easy to clean and to pull off and to stick on too a new jar. When cleaning i just pull the whole lid off, and the lid to the food saver vacuum and i run hot water with i a cap full of bleach threw the hoses and let air dry!

That is it folks! good luck! i am sure you will love your new milker as much as i do mine.